• 1. Boot up Mu-so with no Ethernet connected.
  • 2.

    Wait until Mu-so is fully booted and the LED is flashing purple.

    Note: If Mu-so has been connected previously to a network, do the following:
    • Use the Mu-so pin-hole tool to press the pin-hole button on the side of the unit for 1 second (make sure no device is connected to the USB port).
    • Wait for the Network LED to start flashing purple.
  • 3. Using your computer, open the wireless network settings.
  • 4. Click Mu-so-X000-Setup.
    Note: The letter and number combination shown could be different as this is a unique identifier if multiple Mu-so devices exist on the same network.
  • 5. A purple LED indicates that Mu-so has detected wireless networks, but not yet connected.
  • 6. Click Connect.
  • 7. Open an Internet browser.
  • 8. Click on the address bar.
  • 9. In the address bar, type 192.168.1.12 then press Enter.
  • 10. You will be directed to the Mu-so setup page. Click NETWORK.
  • 11. Click Choose Network.
  • 12. Select your wireless network.
  • 13. Enter the password for your wireless network.
  • 14. Click Enter.
  • 15. Mu-so will now attempt to connect to your wireless network. If successful, the side LED will change to white within 30 seconds.